DL-LYJ-8MG350 casting machine mainly uses a laser displacement sensor to control the liquid level.
The slurry in the material box is placed through the feed defoaming tank, made by a blade to form a thin film blank, and then dried, corrected, trimmed and cut.
The drying is divided into three zones, 12 sections of the bottom baseband are heated independently, and the upper wind heating box is used.
Trimming slices are cut with a round knife.
It is widely used in research institutes and enterprises.
Overview
Suitable for production with thickness from 20 to 1500um
Advanced drying regimes, baseband heating and upper wind Drying zone
Automatic feeding system, film tape calibration, liquid level height up to 40.0mm
Cutting-edge Technology
Liquid level height measurement: Laser or Ultrasound
Multiple independent drying zones, 12 segments of the bottom baseband are heated independently
High precision: doctor blade height 5-4500um, general viscosity: 300-50000 (mpa.s)
Technical specification | Medium Tape Casting Machine DL-LYJ-12MG350 |
Casting width | 350mm |
Casting speed | 0.05 - 6.0 (m/min) |
Casting thickness | 10um - 1500um |
Scraper gap control | Manually turning the knob to rotate the screw rod controls the gap, |
Casting thickness accuracy | ±(1um+2%belt thickness) |
Baseboard temperature control | RT - 120℃ (±0.1℃), the max inlet air temperature is 150℃ |
Dry area | Length 12 meters, divided into 3 areas, 12 sections of base plate with |
Liquid level height | 0.0 - 40.0mm |
